Rack-Mounting The Chassis In A Nebs-Compliant Mode - Cisco Catalyst 9404R Switch Hardware Installation Manual

Installing the Switch
The 23-inch rack mount kit consists of the following items:
Table 7: Contents of 23 Inch Rack Mount Kit
Quantity
2
6
6

Rack-Mounting the Chassis in a NEBS-Compliant Mode

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Statement 1006
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of:
40°C. Statement 1047
Before you begin
Prepare for the installation as follows:
• Place the chassis on the floor or on a sturdy table as close as possible to the rack. Leave enough clearance
• Open the rack-mount kit and verify that all parts are included.
heaviest component at the bottom of the rack.
unit in the rack.
to allow you to move around the chassis.
Rack-Mounting the Chassis in a NEBS-Compliant Mode
Parts Description
Rack Mounts
M4 Phillips pan-head screws
12-24 x 3/4-inch Phillips binder-head screws
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
67