Electrical; Grounding - Graco ProMix 2KE Operation

Installation

Electrical

Power Connection (non-IS units only)
All electrical wiring must be completed by a qualified
electrician and comply with all local codes and
regulations.
Enclose all cables routed in the spray booth and high
traffic areas in conduit to prevent damage from paint,
solvent, and traffic.
The ProMix 2KE operates with 85-250 VAC, 50/60 Hz
input power, with a maximum of 2 amp current draw.
The power supply circuit must be protected with a 15
amp maximum circuit breaker.
Not included with system:
• Power supply cord compatible to your local power
configuration. Wire gauge size must be 8-14 AWG.
• The input power access port is 22.4 mm (0.88 in.) in
diameter. It accepts a bulkhead strain relief fitting or
conduit.
1. Open Control Box cover.
2. Connect electrical cord as shown.
3. Follow instructions in Grounding.
Line
Neutral
F . 7. Control Box Electrical Connection
IG
16
Ground
ti16391a

Grounding

The equipment must be grounded. Grounding
reduces the risk of static and electric shock by
providing an escape wire for the electrical current due
to static build up or in the event of a short circuit.
Connect the ProMix 2KE ground wire to the ground
screw. Connect the clamp to a true earth ground. If wall
power is used to power controls, ground electrical con-
nection according to local codes.
F . 8. Ground Screw and Power Switch
IG
Gun Flush Box
Connect a ground wire from the Gun Flush Box ground
lug to a true earth ground.
Feed Pumps or Pressure Pots
Connect a ground wire and clamp from a true earth
ground to the pumps or pots. See pump or pressure pot
manual.
Air and Fluid Hoses
Use grounded hoses only.
Spray Gun
Follow the grounding instructions in your gun manual.
Fluid Supply Container
Follow local code.
AC Power
Switch
Ground
Screw
TI15712a
3A0868A