Additional Information; Software-Dependent Functions; Disassembly; Maintenance - LOGICDATA TOUCH Series Manual

8 ADDITIONAL INFORMATION

8.1

SOFTWARE-DEPENDENT FUNCTIONS

A full list of Software-Dependent Functions can be found in the Operating Manual of the installed Control
Box.

8.2 DISASSEMBLY

To disassemble your Handset, ensure that it has been disconnected from the Power Unit. Then, follow the
assembly instructions in reverse order.

8.3 MAINTENANCE

All Handsets in the TOUCH Family are maintenance-free for their entire service lifetime.
WARNING Risk of death or serious injury through electric shocks and other hazards
Using a Handset alongside unauthorized spare or accessory parts may lead to death or
serious injury through electric shocks and other hazards.
• Only use accessory parts produced or approved by LOGICDATA
• Only use replacement parts produced or approved by LOGICDATA
• Only allow Skilled Persons to perform repairs or install accessory parts
• Contact customer services immediately if the system malfunctions
The use of unauthorized spare or accessory parts may cause system damage. Warranty
claims are void in this scenario.

8.3.1 CLEANING

1. Disconnect the height-adjustable desks power supply from the power source.
2. Wait 30 seconds for residual voltage to dissipate.
3. Wipe the surface of the Handset with a dry soft cloth or a soft cloth lightly moistened in water.
Never immerse the Handset into any liquid.
4. Wait for the Handset to dry completely.
5. Reconnect the power supply.

8.3.2 REPLACING A HANDSET

1. Disconnect the Control Box from the Mains.
2. Disconnect the Handset from the Control Box.
3. Remove the Handset from the Table Top.
4. Mount the new Handset onto the Table Top.
5. Plug the Handset back into the Control Box.
6. Reconnect the Control Box to the Mains.
TOUCH FAMILY - OPERATING MANUAL // PAGE 27