Table of Contents
Advertisement
Installation manual
3-9000-771
6. On the Overview page, click Alert Setup and select the Flow Analysis tab and
7. On the Overview page, click the Service Tools tab and select the Variables tab. The
8. Click OK to return to the Overview page.
9. Enable the Write Protect switch on the CPU Module to protect the meter's
10. From the Overview window, click Display Meter K-Factors. K-Factors are a read-
Installation manual
enable Reverse Flow. Click the OK button to return to the Overview page.
Flow Data, Path Information, Flow Totals, and All Variables data is populated after
you are connected to the meter.
a) Click the Flow Data tab and view the Flow Direction (Forward or Reverse),
Average Flow and Average Sound Velocities values.
b) Click the Path Information tab and view the Chord performance, Gain, SNR
(Signal to Noise Ratio) Signal strength (mV), and Noise (mV).
c) Click the Flow Totals tab to view the volume totals (forward and reverse
uncorrected volume).
d) Click the All Variables tab to view a graphical display of the Primary,
Secondary, Third and Fourth Variables.
Figure 4-7: AMS Device Manager - Service Tools All Variables status
indicators
configuration.
only values calculated from the Full scale volumetric flow rate used with frequency
outputs and the Maximum frequency for frequency output.
Configuration
May 2019
69
Advertisement
Table of Contents
