Daikin VAM 350GJVE Service Manual page 36

Si71-502
Mode No. Setting
switch
Group Individual
No.
settings settings
0
2
19 29
3
8
Note:
1.
2. The settings are applied to the entire group, but if the mode no. inside the parentheses is selected, the settings
3. Do not set anything not shown above. If the applicable functions are not available, they will not be displayed.
4. When returning to normal mode, the remote controller is initialized, so the display might show "88."
5. Group number setting for centralized controller
6. Details of external input setting
7. Details of external input terminal function are as follows:
Setting position
Control Functions
Description of Setting
Ventilation air flow setting
Ventilation mode setting
"Fresh Up" on/off setting
Electric heater setting
indicates the setting position at the factory.
can be applied to individual indoor units.
However, it is only possible to check any changes made to the settings inside the parentheses in individual
mode.
(For group batch operation, the changes are made but the display remains as it was when shipped from the
factory.)
(1) Mode No. 00 : Group controller
(2) Mode No. 30 : Individual controller
* Regarding the setting procedure, refer to the section "Group number setting for centralized control" in the
operating manual of either the on/off controller or the central controller.
"Last command"........... Only when HRV units are in independent operation. External input is not available with interlocked operation
of HRV units and air conditioners.
"Priority on external input" ... Remote controllers are available while the external input terminal is closed. Remote
controllers are not available while the external input terminal is open. External input is not available with
interlocked operation of HRV units and air conditioners.
"Priority on operation" ... Either air conditioner remote controllers with interlocked operation of HRV units and air
conditioners, or external input is in operation, when HRV units are in operation.
Setting is available with interlocked operation of HRV units and air conditioners.
Input contact Fan operation
01 a
02 a
03 a
04 b
05 b
06 a
* Setting position "04" does not function with interlocked operation of HRVs and air conditioners.
Setting position No. (NOTE 1)
01 02
Low Low
Automatic Exchange By pass
Off On
On, off
No delay Exchange
Operation lamp
ON Turn ON Fresh up operation
ON Turn ON Malfunction code indicates "60"
OFF Blinking Malfunction code indicates "60"
OFF Turn OFF Automatic reset OFF
OFF Turn ON Automatic reset ON
ON Turn ON Air flow rate increases (Low→High, High→Ultra high)
Control Functions
03 04 05
Low Low High
– –
– – –
On, off
–
delay delay
06
High
–
–
–
C : 3P034928-5J
27