Daikin VAM 350GJVE Service Manual page 84

Si71-502
∗27 Display "NOT AVAILABLE"
∗28 Ventilation fan mode selector button
∗29 Ventilation fan speed control button
∗30 Display "
31 Display "FRESH UP"
Note • In contradistinction to actual operating situations, the display on figure 3 shows all possible indications.
• If the filter sign lamp lights up, clean the air filter as explained in the chapter "MAINTENANCE". After
Operation Manual
• "NOT AVAILABLE" may be displayed for a few seconds if the function for the button pressed is not
available for the unit or the air conditioner.
• "NOT AVAILABLE" is only displayed when none of the indoor units is equipped with the function in
question when running several units simultaneously. It is not displayed if the function is available on
even one of the units.
(available only connecting the HRV unit)
This is pressed to switch the fan mode of the HRV unit.
(available only connecting the HRV unit)
This is pressed to control the fan speed of the HRV unit.
(Refer to item 11)
" (operation standby)
It indicates the pre-cooling/pre-heating operation. This unit is at stop and will start operation after the
pre-cooling/pre-heating operation is over.
Pre-cooling/pre-heating operation means the operation of HRVs is delayed during the startup
operation of linked air conditioners such a before the office hours.
During this period the cooling or heating load is reduced to bring the room temperature to the set
temperature in a short time.
This displays the status of two fans. Refer to "Operation Procedure"
cleaning and reinstalling the air filter: press the filter sign reset button on the remote controller. The filter
sign lamp on the display will go out.
What to do Before Operation
75