Appendix; Decommissioning And Packaging; Approvals And Certifications - ABB Sensyflow FMT400-VTS Commissioning Instructions

Appendix

9 Appendix
9.1

Decommissioning and packaging

Packaging the device ready for transport or return to the manufacturer
If the original packaging material is no longer available, wrap the device in bubble wrap or
corrugated cardboard and place it in a box of sufficient size lined with a shock-absorbing
material (e.g., foam rubber). The thickness of the padding should be appropriate for the device
weight and type of shipment. The box must be handled with care and labeled accordingly.
For overseas shipment, always add a desiccant (e.g., silica gel) and hermetically seal the
device plus desiccant in a layer of polythene that is 0.2 mm thick. Use an amount of desiccant
that is appropriate for the packing volume and the expected transport time (at least sufficient for
3 months). You should also line the box with a layer of union paper.
All devices returned to the manufacturer must be accompanied by a completed and signed
decontamination certificate (see Appendix). Without this, ABB will not be able to process the
return.
9.2

Approvals and certifications

CE mark
Explosion
protection
Calibration
IMPORTANT (NOTE)
All documentation, declarations of conformity and certificates are available in ABB's download
area.
www.abb.com/flow
26 - EN
The version of the device as provided by us meets the requirements of the
following European directives:
- EMC Directive 2014/30/EU
- ATEX Directive 2014/34/EU
Designation relating to intended use in potentially explosive atmospheres in
compliance with:
- ATEX Directive
DAkkS- / ILAC-accredited calibration equipment D-K-15081-01-00
- Example certificate
Sensyflow FMT400-VTS, FMT400-VTCS CI/FMT400-VTS/VTCS-EN