1/2” or 3/4” conduit. For Surface Raceway - Remove knockout “D” or “E”. This opening accommodates PANDUIT LD10 surface raceway. 1.2 Locate the wall studs. Position the enclosure on the wall and identify which keyed knockouts should be removed. It is recommended that two of the mounting holes be aligned with the wall stud.
Page 3
Please read these instructions in their entirety prior to installing the enclosure. Note: P Enclosures Require one of the following additional part numbers for in ceiling applications PANDUIT Part #:PZWIFIDCB - P Wireless Access PANDUIT Part #:PZW2X2DCB - P Wireless Access Point Point In Ceiling Bracket Kit In Ceiling 2’x 2’...
Page 4
6.10 To secure the enclosure, wrap each hanger wire tightly around itself a minimum of three times. 6.11 Replace the adjacent ceiling tile. For Technical Support: www.panduit.com/resources/install_maintain.asp Page 4 of 6...
Page 5
8.2 AP-Universal Bracket: Mount vendor- supplied wireless access point mounting frame to The Panduit-supplied Wireless Access Point Mounting Plate using Panduit- supplied (4) #8-32 X 1/4" Screws. Holes are aligned to inner rectangular orientation Vendor-Supplied wireless...
Page 6
10.3 Secure with the Nuts and Washers that are on the stud. PZWE35 shown PZWC35 with completed Wireless PZWC35e with completed Wireless Access Point Assembly Access Point Assembly E-mail: For Instructions in Local Languages cs@panduit.com and Technical Support: Fax: www.panduit.com/resources/install_maintain.asp www.panduit.com (708) 444-6448 Page 6 of 6...