Triumph Bonneville Bobber 2016 Owner's Handbook Manual page 31

Warning
After selecting a riding mode, operate
the motorcycle in an area free from
traffic to gain familiarity with the new
settings.
Do not loan your motorcycle to anyone
as they may change the riding mode
setting from the one you are familiar
with, causing loss of motorcycle control
and an accident.
Press and release the MODE button on
the left hand handlebar switch housing
until the desired riding mode is flashing
in the display.
Within 30 seconds of pressing the
MODE button the rider must carry out
the following simultaneously:
• Close the throttle.
• Pull the clutch in.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note:
• The riding mode will default to ROAD
when the ignition is switched ON.
In the event of an incomplete riding
mode change:
• Safely bring the motorcycle to a
stop.
• Select neutral gear.
• Turn the ignition OFF and then back
ON again.
• Select the desired riding mode.
• Restart the engine and continue
riding.
General Information
Warning
Do not stop the engine using the
ignition switch or engine start/stop
switch while the motorcycle is moving.
Always bring the motorcycle to a stop
safely and engage neutral gear prior to
stopping the engine.
Stopping the engine by turning off the
ignition or engine start/stop switch
while the motorcycle is moving can lock
the rear wheel
motorcycle control and an accident.
Caution
Do not stop the engine using the
ignition switch or engine start/stop
switch while the motorcycle is moving.
Stopping the engine by turning off the
ignition or engine start/stop switch
when the motorcycle is moving may
cause damage
components.
causing loss of
to motorcycle
31