Hot-Key Commands - StarTech.com STARVIEW SV1631DUSB Instruction Manual

NOTE: It is unnecessary to switch the Sun mark ON or OFF if an
authentic Sun keyboard is being used on the console. In other words,
you must ensure that the Sun-marked port has not been selected if you
are already using a Sun keyboard.
With different types of keyboard and computer, the Sun Mark must be
set up in compliance with the following instruction:
Keyboard Type
USB (non-Sun)
USB (non-Sun)
USB (Sun keyboard)
USB (Sun keyboard)
ESC: To exit the OSD, press the <ESCAPE> key

Hot-key commands

Hot-key command is a short keyboard sequence used to select
a computer, to activate computer scan, etc. StarView interprets
keystrokes followed by one or two more keystrokes. A built-in buzzer
generates a high-pitch beep for a correct hotkey command, otherwise,
one low-pitch beep for an error and the bad key sequence will not be
forwarded to the selected computer.
The short form hotkey menu can be turned on as an OSD function
(<F4>:More\Hotkey Menu) every time the left <CTRL> is pressed twice.
NOTE: Left <CTRL>: refers to the Control key on the left side of the
keyboard.
refers to the number keys '1'~'8' in the upper row of the
1~8/A~H:
keyboard and character keys 'A' ~ 'H'. Do not use the keypad
at the right of the keyboard.
To select a computer by hotkey command, you must know its port
number, which is determined by the KVM Switch connection. For a
entitled Sun Keyboard Mapping for further detail.
Computer Type
PC/Mac
Sun
PC/Mac
Sun
12
Sun Mark
No
Yes
No
Yes