Command Summary; Star Mode - Star Micronics TSP552 User Manual

This printer supports two different command modes: the Star mode and the ESC/
POS mode.
This chapter provides you with all of the commands supported by this printer.
Important!
Access the following URL for the latest version of this manual and for
updates on supported commands: http://www.star-micronics.co.jp/
service/sp_sup_e.htm

7-1. Star Mode

Commands to Select Characters
Control codes
<ESC> "R" n
<ESC> <GS> t n
<ESC> "/" "1"
<ESC> "/" <1>
<ESC> "/" "0"
<ESC> "/" <0>
<ESC> "b" n1 n2 n3 n4 1B 62 n1 n2 n3 n4
d1 ... <RS>
<ESC> "M"
<ESC> "p"
<ESC> "P"
<ESC> ":"
<ESC> <SP> n
<SO>
<DC4>
<ESC> "W" n
<ESC> <SO>
<ESC> <DC4>
<ESC> "h" n
<ESC> " – " "1"
<ESC> " – " <1>

7. Command Summary

Hexadecimal
Function
codes
1B 52 n Select international character set
1B 1D t n Select character table
1B 2F 31
Select slash zero
1B 2F 01
1B 2F 30
Select normal zero
1B 2F 00
Select bar code printing
d1 ... 1E
1B 4D Select 12-dot pitch printing
1B 70 Select 14-dot pitch printing
1B 50 Select 15-dot pitch printing
1B 3A Select 16-dot pitch printing
1B 20 n Set character spacing
0E Sets the printing magnified double in
character width.
14 Resets the printing magnified in
character width.
1B 57 n Sets the magnification rate in character width.
1B 0E Sets the printing magnified double in
character height.
1B 14 Resets the printing magnified in character
height.
1B 68 n Sets the magnification rate in character height.
1B 2D 31
Select underlining
1B 2D 01
– 13 –