Removing Remaining Paper - Star Micronics TSP552 User Manual

(6) Set the power switch to on to turn on power to the printer. Make sure that the
ERROR LED is not lit.
Note: While the ERROR LED is lit, the printer will not accept any commands
such as the print command, so make sure that the printer cover is locked
properly.
(7) Issue the cut command to cut off the end of the paper.

6-2. Removing Remaining Paper

(1) Set the power switch to off to turn off power to the printer.
(2) Pull the lever toward you to open the printer cover.
Note: Make sure that the lever is pulled until it stops at the stopper. If the lever
is not pulled up to the stopper, the printer cover may not open.
(3) Remove the remaining paper.
– 12 –