Test Print Method; Producing A Test Print; Hexadecimal Dump - Star Micronics TSP2000 Series User Manual

Star micronics thermal printer user's manual tsp2000

Hide thumbs Also See for TSP2000 Series:

Table of Contents

Available languages

To start test print, set the power switch to off, set the paper in place, then set the

power switch to on while holding down the FEED switch. Release the switch

within three seconds.

When a certain amount of printing is performed, the printer will cut the paper and

stop automatically.

This prints data sent from the host in hexadecimal format and in the correspond-

ing ASCII characters. This is useful for debugging applications and for analyzing

scrambled characters.

Starting and stopping Hex Dump printing

While holding down the Feed switch, turn the power on. Hold down the switch

for five seconds; Hex Dump will begin operation when the switch is released.

If the switch is released within three seconds, the Self Test will run.

Stop Hex Dump by turning the power off.

8. Test Print Method

The received data is printed as follows.

Address

Hexadecimal data

– 19 –

ASCII data

Table of Contents

Table of Contents