Connecting To A Peripheral Unit - Star Micronics TSP2000 Series User Manual

3-2. Connecting to a Peripheral Unit

You can connect a peripheral unit to the printer using a modular plug. The
following describes how to install the ferrite core and make the actual connection.
See "Modular plug" on page 98 for details about the type of modular plug that is
required. Note that this printer does not come with a modular plug or wire, so it
is up to you to obtain one that suits your needs.
Important!
Make sure that the printer is turned off and unplugged from the AC outlet and
that the computer is turned off before making connections.
Ferrite core (17.5 mm wide)
Connector
One loop
(1) Affix the smaller ferrite core onto
cable
– 6 –
the modular wire as shown in the
illustration below.