Buttons; Producing A Test Print - Star Micronics SCP700 Series User Manual

18

Buttons

The following table describes the function of the two control buttons of the
control panel.
Button
RECEIPT
SLIP/RESUME

Producing a test print

The following procedure can be used at any time to test the receipt printer and
the slip printer.
Turn on the printer and insert a piece of paper into the slip printer
(page 13). Also make sure that roll paper is loaded for the receipt printer
(page 9).
Note:
If you want to produce a test print on the receipt printer only, simply don't
insert paper into the slip printer.
Turn off printer power.
While holding down the RECEIPT button, turn printer back on. Keep
RECEIPT depressed for a few moments until the printer beeps and the
receipt printer test print starts.
After the receipt test print is complete, the slip printer will produce a test
print on the paper you inserted in the first step of this procedure. The slip
printer test will continue until it reaches the end of the paper.
Note:
The slip printer momentarily releases the slip paper when you turn printer
power back on. If you are using a large piece of paper, it may fall out of the slip
printer when this happens, causing the slip printer test to be skipped. Because
of this, it is a good idea to keep hold of the paper in the slip printer when you
turn power back on.
Press to feed the thermal paper. Holding down this button feeds paper
at high speed.
1. Press this button to release or engage slip paper from the slip
printer.
2. Press this button to clear the errors of the slip printer and receipt
printer.
Description