Star Micronics TSP2000 Series User Manual page 11

5 cm
maximum
Note: Before connecting/disconnecting the peripheral drive cable, make
sure that power to the printer and all the devices connected to the
printer is turned off. Also make sure the power cable plug is discon-
nected from the AC outlet.
(1) Connect the peripheral drive cable to the connector on the rear panel of the
printer.
Fastener
Pull and cut
– 7 –
(2) Pass the fastener through the ferrite
core.
(3) Loop the fastener around the cable
and lock it. Use scissors to cut off
any excess.
(4) Plug one end of the modular cable
into the modular jack of the periph-
eral.
(5) Remove the modular jack cover
from the back of the printer and plug
the other end of the modular cable
into the jack of the printer.