6.
HEX Dump Mode/Test Print
You can enter the HEX Dump Mode and run Test Prints by turning ON the power supply while pressing the RESUME
switch. The HEX Dump mode prints the data sent from the host computer in HEX data format.
1)
Turn ON the power supply while pressing the RESUME switch.
2)
Release the RESUME switch using the following timing to set each mode.
Near-end Sensor Board LED
2 Sec
HU Lights
a
PE Lights
b
Releasing at a: HEX Dump Mode
Releasing at b: Test Print
– 13 –