Connections Setup; Wan - D-Link DIR-878 User Manual

DIR-878 AC1900 MU-MIMO Wi-Fi Gigabit Router
User Manual

Connections Setup

In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).

WAN

On the Connections Setup / WAN page, you can create and edit connections used by the router.
By default, a Dynamic IPv4 connection is configured in the system. It is assigned to the WAN
port of the router.
Figure 50. The Connections Setup / WAN page. The simplified mode.
To edit an existing connection, click the EDIT button. On the opened page, on the Basic tab, the
mandatory settings of this connection will be displayed. To view all available settings of the WAN
connection, go to the All Settings tab. Change the needed parameters and click the APPLY
button.
To disconnect a connection and establish it again, click the RECONNECT button.
To remove an existing connection and create a new one, click the CHANGE CONFIGURATION
button. Upon that the connection creation page opens.
To create several WAN connections, go to the advanced mode. To do this, click the ADVANCED
MODE button.
!
When connections of some types are created, the Connections Setup / WAN page is
automatically displayed in the advanced mode.
Page 63 of 191
Configuring via Web-based Interface