D-Link DIR-878 User Manual page 156

DIR-878 AC1900 MU-MIMO Wi-Fi Gigabit Router
User Manual
You can specify the following parameters:
Parameter
Enable rule
Name
Action
Protocol
IP version
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Set as
General settings
Move the switch to the right to enable the rule.
Move the switch to the left to disable the rule.
A name for the rule for easier identification. You can specify any
name.
Select an action for the rule.
Allow: Allows packet transmission in accordance with the criteria
specified by the rule.
Deny: Denies packet transmission in accordance with the criteria
specified by the rule.
A protocol for network packet transmission. Select a value from the
drop-down list.
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
Source IP address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP address
Select the needed value from the drop-down list.
Page 156 of 191
Configuring via Web-based Interface
Description