Controls, Alarms And Indicators; Pump Controls - Getinge Arjohuntleigh Nimbus 3 Professional Instructions For Use Manual

4. Controls, Alarms and Indicators

Power Switch
& Alarm Reset
N
On/Reset Alarm
Indicator
Pump Controls The pump front panel has the following controls:
POWER Switch (and
RESET ALARM)
STATIC Mode
Alarm MUTE
COMFORT CONTROL
mmHg
Mute Control
& Indicator Indicator
R
Static Control
& Indicator
Switches the mains power to the pump on and off.
The green indicator is illuminated when the mains
power is connected and the pump switched on.
The switch is also used to reset the pump after an alarm
condition has been detected.
Selects the operating mode, either
mode is confirmed when the yellow indicator on
Static
the button is illuminated.
When
Dynamic
indicator will be extinguished.
An audible alarm mute is provided to cancel warning
sounds during an alarm condition.
This is a rotary action control to set the relative firmness/
softness of the mattress for patient comfort.
+
Alarm High Pressure
Indicator
Hi
mmHg
Wait Service
Indicator Indicator
Power Fail
Indicator
mode (default) is selected the yellow
11
Low Pressure
Indicator
mmHg
-
+
mmHg
Lo
Comfort
Control
Pump Fault
Indicator
or
Static Dynamic
.