Table of Contents
Advertisement
Operating Instructions
3. Safety
The SolidFlow 2.0 measuring system has a state of the art, reliable design. It was tested and found to be in a
perfectly safe condition when leaving the factory. Nevertheless, the system components may present dangers to
personnel and items if they are not operated correctly.
Therefore, the operating manual must be read in full and the safety instructions followed to the letter.
If the device is not used correctly for its intended purpose the manufacturer's liability and warranty will be void.
3.1 Normal use
The measuring system may only be installed in metallic pipes to measure the medium passing through
•
them.
It is not suitable for any other use or measuring system modifications.
Only genuine spare parts and accessories from SWR engineering may be used.
•
3.2 Identification of hazards
Possible dangers when using the measuring system are highlighted in the operating instructions with
•
the following symbols:
Warning!
This symbol is used in the operating manual to denote actions which, if not performed correctly may
•
result in death or injury.
Attention!
This symbol is used in the operating manual to denote actions which
•
may result in danger to property.
3.3 Operational safety
The measuring system may only be installed by trained, authorised personnel.
•
During all maintenance, cleaning and inspection work on the pipelines or SolidFlow 2.0 components,
•
make sure that the system is in an unpressurised state.
Switch off the power supply before performing any maintenance work, cleaning work or inspections on
•
the pipelines or the SolidFlow 2.0 components. See the instructions in the section entitled Maintenance
and care.
The sensor must be taken out of the pipeline before any welding work is performed.
•
The components and electrical connections must be inspected for damage at regular intervals. If any
•
signs of damage are found, they must be rectified before the devices are used again.
3.4
Technical statement
The manufacturer reserves the right to adjust technical data concerning technical developments without
•
notice. SWR engineering will be delighted to provide information about the current version of the
operating manual, and any amendments made.
6
Advertisement
Table of Contents
