Safety; Regular Use; Marking Of Dangers; Operational Safety - SWR M-Sens 2 Manual

3. Safety

The measuring system M-Sens designed and built according the latest technology has been
tested to be safe and was shipped in safe condition. Nevertheless persons or objects may be
endangered by components of the system if these are operated in an inexpert manner. There-
fore the operational instructions must be read completely and the safety notes must be fol-
lowed. In case of inexpert or irregular use, the manufacturer will refuse any liability or guar-
antee.

3.1 Regular Use


Only original spare parts and accessories of SWR engineering must be used.

3.2 Marking of dangers

Possible dangers when using the measuring system are marked by the following symbols in
the operating instructions:

3.3 Operational safety


The measuring system must be installed by trained and authorised personnel only.

Switch off the supply voltage for all maintenance, cleaning or inspection works on the
tubes or on components of the M-Sens 2. Follow the notes of the chapter "mainte-
nance".

Before hot-work the sensor must be removed from the installation place.

The components and electrical connections must be checked for damages regularly.

If a damage is found, it is to be repaired before further operation of the instruments.
5
This symbol in the operating instructions marks actions,
which may represent a
danger for life and limb of persons when carried out in an inexpert
manner.
Danger!
All actions which may endanger objects are marked with this symbol in the
operating instructions.
Warning!