Operating Instructions
• Now insert the sensor into the sensor guide as shown in Figure 8a.
and align it longitudinally to the pipe axis as shown on the polarisation sticker (Fig. 8b).
•
Then seal the measurement point with the union nut.
Make sure you install a drip loop with the cable anywhere it may get wet to prevent
•
water flow from reaching the sensor.
1
2
Locking ring 20 x 1.2
Padding ring 1 mm
Union nut
Sensor
Sensor mount
Round seal 19 x 2
Spacer ring(s) 1 mm each
Fig. 8b: Sensor alignment
Fig. 8a: Install the
sensor mount
and the sensor
Drip Loops
9