Performing Repeat Cutting - Roland CAMM-3 PNC-300 User Manual

Performing Repeat Cutting

The repeat cutting function cannot be used unless the PNC-300's memory buffer has been expanded to 1 MB.
The data buffer is the place where data received from the computer is stored temporarily. (The data in the data buffer can be erased by
switching off the power or executing the "BUFFER-CLEAR".)
Executing the "REPEAT" calls up the cutting data stored in the PNC-300's data buffer and executes the replotting procedure.
When replotting is executed, the entire data content of the data buffer is called up. When you perform replotting, clear the data from the data
buffer before sending the cutting for replotting from the computer.
1
Press the [MENU] key to make the following screen
appear on the display.
3
Install the tool (blade) and load the material. After
closing the cover, use the software to send cutting
data.
5
Press the [MENU] key to make the following screen
appear on the display.
2
Press the [ ] key to move the blinking cursor (" ") to
"BUFFER-CLEAR," and then press the [ENTER]
key.
4
After cutting has finished, remove the cut material
and load a new piece. Set the origin point if neces-
sary.
6
Press the [ ] key to move the blinking cursor (" ") to
"REPEAT," and then press the [ENTER] key.
25