Part Names And Functions - Roland CAMM-3 PNC-300 User Manual

2. Part Names and Functions

Head
This moves the spindle (cutting tool) up
and down). The head performs Z-axis
movement.
Installed on the spindle
Collet chuck and collet cap
These secure the cutting tool
(blade) to the spindle.
XY table
The XY table grips the workpiece to be cut,
and shifts it forward, backward, and to the
sides. The XY performs X- and Y-axis
movement.
Described on the following page
Serial connector
A serial (RS-232C) cable is
connected here.
Parallel connector
A parallel (printer) cable is
connected here.
Power connector
The power cord included
with the machine is
connected here.
2
EMERGENCY STOP switch
This switch cuts the power supply and forces the
machine to stop, regardless of whether operation is in
progress. Press the EMERGENCY STOP switch
immediately if dangerous or abnormal operation occurs.
Left side view
Cover
Opening the cover during cutting
results in an emergency stop. Any
cutting data in use becomes invalid,
and cutting cannot be continued.
If the cover must be opened during
cutting, first press the [ENTER/
PAUSE] key to pause the PNC-300,
then open the cover. After the cover
has been closed, cutting resumes
when the paused state is canceled.
The spindle will not rotate while the
cover is open.
Canceling an emergency stop
Rotate the red portion of the
switch clockwise.
Z0 position sensor jack
The Z0 position sensor included
with the unit is connected here.
Vacuum cleaner mounting port
* A vacuum cleaner is not included with the unit.
The suction nozzle of a commercially available
vacuum cleaner can be inserted into this port. This
allows the vacuum cleaner to remove cuttings during
operation.
Power switch
Rear view