Setting The Connection Parameters - Roland CAMM-3 PNC-300 User Manual

5. Setting the Connection Parameters

Connection with a parallel cable is called a "parallel connection," and connection with a serial cable is called a "serial connection."
Make the appropriate settings on both the computer and the PNC-300 to configure the equipment for the type of connection that has
been made. Normally, the setting on the PNC-300 should be made to match the setting on the computer. The steps below describe how
to set connection parameters on the PNC-300. To make the settings on the computer, refer to the manual for the computer or the
software in use.
1
Press the [MENU] key to make the following screen
appear on the display.
3
Press the [MENU] key to make the following screen
appear on the display.
5
Press the [ENTER] key.
7
Make the settings for stop bit, data bits, and parity
check, then press the [MENU] key once.
8
* "REPEAT" is displayed only
when the buffer size has been
expanded.
Make sure
that "< >" appears.
For serial connection
only
2
Press the [ ] key to move the blinking cursor (" ") to
"OTHERS," and then press the [ENTER] key.
4
Press the [ ] key to move the blinking cursor (" ") to
"I/O," then use the [ ] or [ ] keys to select "AUTO."
6
Press the [MENU] key once.
8
Make the settings for baud rate and handshake.
For serial connection
only
For serial connection
only