Roland CAMM-3 PNC-300 User Manual page 7

Do not install in an unstable or high
location.
Do not installation the machine on the edge of a
table, or it may fall.
Handle the power cord with care.
Do not step on or damage the power cord, or
allow heavy objects to be placed atop it. Failure
to heed this may result in electrocution or fire.
Do not use cutting oil when
performing cutting.
Perform dry cutting with no cutting oil. Use of
cutting oil may result in fire or machine failure.
Do not block the ventilation holes.
Blocking the ventilation holes at the rear of the
unit may prevent heat radiation and cause fire.
Do not allow liquids, metal objects or
flammables inside the machine.
Fire or breakdown may result.
Wash hands when finished.
Wash hands with water to remove any adhering
cutting chips.
iv