Height Adjustment; Operational Instructions - Stamina 55-1539 Owner's Manual

OPERATIONAL INSTRUCTIONS

GENERAL PRECAUTIONS
1. Do not use the Therapy Inversion System alone. Always have a helper available in case assistance is
needed in recovering from the decline position.
2. Make sure that the FOAM PADS(16) and HEEL HOLDERS(19) are holding your feet securely.
Make sure that the HEIGHT ADJUSTMENT BEAM(12) is properly set for your height.
3.
4. Make sure that the HEIGHT ADJUSTMENT BEAM(12) is held securely by both the SPRING PIN(22)
and the SECURING KNOB(23).
Make sure that there is enough room for the bed to rotate completely.
5.

HEIGHT ADJUSTMENT

Therapy Inversion System
The
weight distribution. It is very important to make sure that the height adjustment is adjusted properly. Use
the following procedure to set the height adjustment and balance the
NYLON STRAPS
1. Adjust the
movement to approximately 15 degrees
beyond the horizontal position. The nylon
straps should not allow the
Inversion System
inversion position while you are setting the
height adjustment.
SECURING KNOB(23)
Loosen the
2.
MAIN FRAME(4).
the
SPRING PIN(22)
3.
Pull the
SCALE DECAL(20)
ADJUSTMENT BEAM(12).
4.
SECURING KNOB(23).
Tighten the
5.
Mount the machine.
6. Lock your ankles into the
HEEL HOLDERS(19).
and
7.
Lie back with your hands at your sides.
8.
Slowly raise your hands to your chest.
9. If your feet are higher than your head, dismount and try a taller setting. If you do not rotate to a position
close to level, dismount and try a shorter setting.
NOTE: The
Therapy Inversion System
below your waist. If it does not, use a taller setting.
HANDRAILS
Therapy Inversion System
The
Handrails are connected to the bed with linkages so that pulling on the Handrails will move the bed away
from the inverted position toward the upright position.
1. Pull the Handrails to pull yourself to the upright position from any degree of inversion. If you wish to
return to the upright position and the bed is not moving or moving too slowly, grasp and pull the Handrails
until you return to the upright position.
Grasp the Handrails to control the speed of inversion or stop the inversion.
2.
WARNING:
Make sure that the Handrails are functioning properly before going into full inversion.
is a very sensitive balance device. It responds to very slight changes in
to restrict
Therapy
to go into the full
under
and use the
HEIGHT
to set the
FOAM PADS(16)
should return to the upright position when your hands are
features a set of Handrails for added convenience and safety. The
Therapy Inversion System.
10