Side Roller Adjustment - Stamina AeroPilates Pro XP686 Owner's Manual

SIDE ROLLER ADJUSTMENT

There are four SIDE ROLLERS(48) on the bottom of the CARRIAGE(42). The two SIDE ROLLERS (48) on
the right side are adjustable. These rollers were preset in the correct position at the factory. If the carriage
does not travel smoothly in the rails, the rollers on the right side can be adjusted using the procedure below.
CARRIAGE IS TOO TIGHT IN THE RAILS
1.
Loosen the NYLOCK NUTS(M8x1.25)(103) on both adjustment assemblies.
NUT(M8x1.25)(103) from the CARRIAGE BOLT(M8x1.25x18mm)(82).
2. On both adjustment assemblies, loosen NUT B(M8x1.25)(102) one-half turn. Hold NUT B(M8x1.25)(102)
and tighten NUT A(M8x1.25)(102) securely against the BRACKET and NUT B(M8x1.25)(102). Test the
CARRIAGE(42) to verify that it travels smoothly. Repeat the procedure if necessary.
3. Tighten the NYLOCK NUTS(M8x1.25)(103) on both adjustment assemblies.
CARRIAGE MOVES FROM SIDE TO SIDE IN THE RAILS
1.
Loosen the NYLOCK NUTS(M8x1.25)(103) on both adjustment assemblies.
NUT(M8x1.25)(103) from the CARRIAGE BOLT(M8x1.25x18mm)(82).
2.
On both adjustment assemblies, loosen NUT A(M8x1.25)(102) one-half turn. Hold NUT A(M8x1.25)(102)
and tighten NUT B(M8x1.25)(102) securely against the BRACKET and NUT A(M8x1.25)(102). Test the
CARRIAGE(42) to verify that it travels smoothly. Repeat the procedure if necessary.
3. Tighten the NYLOCK NUTS(M8x1.25)(103) on both adjustment assemblies.
NOTE: The SIDE ROLLER(48) is adjusted approximately 0.050" (1.25mm) for each complete turn of an
adjustment nut.
CARRIAGE BOLT (82)
NUT A (102)
BRACKET
NUT B (102)
(Refer to the Detail Drawing above.)
NYLOCK NUT (103)
(Refer to the Detail Drawing above.)
15
SIDE ROLLER (48)
SIDE ROLLER
ADJUSTOR (50)
DETAIL DRAWING
Do not
remove the NYLOCK
Do not
remove the NYLOCK