Advertisement
®
®
Note: In Windows , you can use the Command Prompt application and in Mac , you can
Terminal application to run the commands for connectivity testing.
ping 192.168.10.50
<Press Enter and wait for result>
ping 192.168.10.51
<Press Enter and wait for result>
A successful connectivity test will appear similar to the result below for each access point. Ping
replies and 0% packet loss will indicate a successful point to point bridge connection between
the two access points.
Note: If the connectivity test fails, wait for about a minute and try again. Make sure there are no
obstacles between the two access points when running the connectivity test and make sure the
two access points are not too close together.
7
Advertisement
