GRAUPNER GR-12L Manual page 18

RECEIVER 1.95
ALARM VOLT: 3.7V
ALARM TEMP: 65°C
PERIOD: 10ms
SENSOR at CH5:
SUMD at CH6: SUMD
RSSI CH : OFF
F.RESET : No
18 / 24
SENSOR at CH5
• "No"
Port 5 is suitable for operating a servo or comparable RC com-
ponents.
Yes
• "Yes"
Port 5 is suitable for connecting HoTT telemetry sensors. When
the receiver is switched on, previously connected compatible
devices are automatically detected.
SUMD at CH6
• SERVO
At output 6, a servo signal is provided.
• SUMD
As soon as the value field of this line is set to "SUMD", the receiver
permanently generates a digital sum signal from the received
control channels and makes this available at port 6.
• SBUS
Port 6 is suitable for connecting to an SBUS-enabled flight control
system, such as: Ardupilot, PX4 or flybarless systems.
• SP2048
The port 6 is suitable for connecting a flight control, the Spektr.
2048 signal can handle. e.g. 48377
RSSI CH
The signal strength of the receiver is output instead of the servo
function on the selected channel at SUMD, SBUS or SP2048. At the
same time, the digital sum signal is adjusted to the number of chan-
nels so that the RSSI signal is applied to the highest channel. This
allows, when using a flight control with OSD, such for example,
48377 to show the signal strength of the receiver in the video gog-
gles or on the screen.
Settings: OFF, CH8, CH12 and CH16
F.RESET
factory
By switching to ON, a factory reset is performed.
The factory reset switches the C9-11 to the outputs 1-3 with switch-
ing function for channel switching of a FPV transmitter 16570.123
via the transmitter.
16570.123_V1sh