For Your Safety By Handling The Transmitter And The Receiver; For Your Safety By Handling The Batteries; Connections - GRAUPNER GR-12L HoTT Manual

For your safety by handling the transmitter and the receiver

WARNING
!
Also while programming the transmitter, make sure that a con-
nected motor cannot accidentally start. Disconnect the fuel sup-
ply or drive battery beforehand.
CAUTION
!
Avoid every kind of short-circuit in all sockets of the transmitter!
Risk of fire! Use only the suitable connectors. In no case the elec-
tronic component of the transmitter or of the receiver may be
changed or modified. Due to licensing reasons, any reconstruction
and/or modification of the product is prohibited.
Note
During transport protect the model and the transmitter from dam-
ages.

For your safety by handling the batteries

CAUTION
!
• Protect the batteries from dust, dirt, moisture, heat and vibra-
tions. Only use in dry locations.
• Do not use any damaged battery.
• Batteries may not be heated, burned, short-circuited.
• If handled improperly, there is a danger of fire, explosion, irri-
tation and burns.
• Leaked electrolyte is caustic and should not be touched or
come into contact with your eyes. In case of emergency, rinse
with a large quantity of water and consult a Med. Doctor.
• Stock the batteries in dry and fresh conditions.
• Dispose of the battery in the proper disposal centers.
8 / 20
Installation

Connections

S1012_GR-12L_DE_V1sh S1012_GR-12L_DE_V1sh
The receiver must be protected against dust, exhaust gases, splash
water, etc. in the model. When you install your receiver, make sure
that it is not excessively airtight to prevent it from overheating during
operation.
Servo cables may not be wound around antennas or run next to
them. Make sure that the cables cannot shift to lie directly adjacent
to antennas during flight.
In the case of carbon fibre fuselage, at least the last 35 mm of the
antennas shall be routed from the fuselage.
Connect the devices that have to be connected to the receiver to the
row of sockets on one end of the receiver. The servo connections of
the Graupner-HoTT receiver are numbered.
The polarity of the plug-in system cannot be reversed. Do not apply
force.
Note
For the GR-12L HoTT receiver, insert the connectors with the brown
or black cable upwards.
9 / 20