Step 5: Using The Applications; Running The Md1 Sfp Application; Windows; Linux - Keysight Technologies U1084A Startup Manual

Step 5: Using the Applications

Step 5: Using the Applications
The following section provides information on using the installed Utilities,
Demonstration applications and Drivers, both for Windows and Linux environments.

Running the MD1 SFP Application

MD1 SFP is an application which is intended to verify the functionality of the module
and to serve as an easy to use and convenient program for capturing, displaying, and
archiving captured data.
This program uses the AgMD1 and other associated drivers to control any supported
digitizers. It is installed at the same time as those drivers.

Windows

There are currently two versions of the SFP application available under Windows. The
SFP 1.x version is gradually being phased out by the introduction of the MD1 SFP (5.x).
However at this point in time the SFP 5 application does not fully support all products,
modes of operation or features that are supported by the SFP 1.x, and so the user
must decide which SFP to use depending on their application.
MD1 SFP (5.x)
The Soft Front Panel SFP 5 can be launched from Start > All Programs > Agilent >
MD1 > MD1 SFP or MD1 SFP_64
MD1 SFP 1.x
This application which was previously known as 'AcqirisLive' has one feature which
the MD1SFP (5.x) does not; that it supports the acquisition from multiple modules
simultaneously. Users who require this feature or prefer this application, may
continue to utilize this version.
To run the application: Start > All Programs > Agilent > MD1 > MD1 SFP 1.x

Linux

To run the MD1 SFP 5 for Linux, enter the following command:
AgMD1SFP5
16 Keysight U1084A Startup Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com