2N Indoor Touch 2.0 User Manual page 19

Put the device on the holder and tighten the safety screws.
5.
Follow the installation instructions printed on the device package.
Power Supply Connection
®
You can feed 2N Indoor Touch 2.0
Use 12 V / 0,75 A DC power adapter (order no. 91378381E/91378381GB
1.
/91378381US)connected to the terminal board (see the figure).
Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernet
2.
switch/router.
A successful operation is indicated by a status RGB LED or LCD display.
PoE Supply Connection
Use a standard straight RJ-45 terminated cable to connect device to the Ethernet. The
device supports the 10BaseT and 100BaseT protocols. The Ethernet connection state
is indicated by
Refer to 3.3 Device Configuration
interface.
Caution
Factory reset results in a change of the Ethernet interface configuration!
A defective Ethernet cable may lead to a high packet loss in the
Ethernet and subsequent instability and poor video call quality!
Warning
Connection of a defective or improper power adapter may lead to a
temporary or permanent failure of the
2N TELEKOMUNIKACE a.s., www.2n.cz
as follows:
the LEDs placed
for the factory settings of the device Ethernet
on the RJ-45
®
2N Indoor Touch 2.0
connector.
unit!
19/135