Removing A 3.5-Inch Hard Drive - HP EliteDesk 800 G5 SFF Maintenance And Service Manual

5. Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of
the drive locks into place (2).
6. Connect the power cable and data cable to the rear of the drive.
7. Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system board
labeled SATA1 or SATA2.
NOTE:
connectors.
8. Reassemble the computer.

Removing a 3.5-inch hard drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
There are two 3.5-inch hard drive bays. The procedure for removing a 3.5-inch hard drive is the same for each
drive bay.
1. Prepare the computer for disassembly
2. Remove the access panel
34 Chapter 4 Removal and replacement procedures
Refer to System board connections on page 23
(Access panel on page
for an illustration of the system board drive
(Preparation for disassembly on page
19).
18).