HP EliteDesk 800 G5 SFF Maintenance And Service Manual page 117

Table 6-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
SATA Power Management (Enable or Disable)
Enables or disables SATA bus or device power management. Default is Enabled.
PCI Express Power Management (Enable or Disable)
Enabling this option permits the PCI Express links to use Active Power State Management (ASPM) to enter
lower power states while not in use. Default is Enabled.
Unique Sleep State Blink Rates (Enable or Disable)
This feature is designed to provide a visual indication of what sleep state the system is in. Each sleep
state has a unique blink pattern. Default is Disabled.
NOTE:
S0 (On) = Solid white LED.
S3 (Stand By) = 3 blinks at 1 Hz (50% duty cycle) followed by a pause of 2 seconds (white LED) — repeated
cycles of 3 blinks and a pause.
S4 (Hibernation) = 4 blinks at 1 Hz (50% duty cycle) followed by a pause of 2 seconds (white LED) —
repeated cycles of 4 blinks and a pause.
S5 (Soft Off) = LED is off.
Power On from Keyboard Ports (Enable or Disable)
When enabled, this feature allows a key press to power on the system when it is off (S5 state). If using a
USB keyboard, it must be plugged into one of the rear ports labeled with the keyboard icon. Default is
Disabled.
Remote Management Active Management (AMT) (Intel only) (Enable or Disable). Default is Enabled.
Options
Allows you to discover, repair, and protect networked computing devices.
USB Key Provisioning Support (Enable or Disable). Default is Disabled.
USB Redirection Support (Enable or Disable). Default is Enabled.
USB redirection allows USB devices plugged into a client computer to be transparently redirected to the
guest operating system.
Unconfigure AMT on next boot (Do Not Apply or Apply). Default is 'Do Not Apply'.
SOL Terminal Emulation Mode (ANSI or VT100). Default is ANSI.
SOL terminal emulation mode is only activated during remote AMT redirection operations. The emulation
options allow administrators to select which mode works best with their console.
Show Unconfigure ME Confirmation Prompt (Enable or Disable). Default is Enabled.
Verbose Boot Messages (Enable or Disable). Default is Enabled.
Verbose boot shows additional logging information during the boot. mainly for debugging if something
goes wrong during bootup.
Watchdog Timer (Enable or Disable). Default is Enabled.
Allows you to set amount of time for a operating system and BIOS watchdog alert to be sent if the timers
are not deactivated. BIOS watchdog is deactivated by BIOS and would indicate that a halt occurred during
execution if the alert is sent to the management console. An operating system alert is deactivated by the
operating system image and would indicate that a hang occurred during its initialization.
●
●
CIRA Timeout (min.) (1, 2, 3, 4, Never)
A normal shutdown goes to the S4 state for Windows 10 or later.
OS Watchdog Timer (min.) – (5, 10, 15, 20, 25). Default is 5 min.
BIOS Watchdog Timer (min.) – (5, 10, 15, 20, 25). Default is 5 min.
Computer Setup (F10) Utilities 107