Dual Top - If Equipped - Jeep Wrangler 2018 User Manual

NOTE:
To reinstall the hard top, follow the removal
instructions in reverse order.
For complete owner information, refer to your
Owner's Manual for further details.
CAUTION!
• The front panel(s) must be positioned
properly to ensure sealing. Improper in-
stallation can cause water to leak into
the vehicle's interior.
• The hard top assembly must be posi-
tioned properly to ensure sealing. Im-
proper installation can cause water to
leak into the vehicle's interior.
• The hard top is not designed to carry any
additional loads such as roof racks,
spare tires, building, hunting, or camp-
ing supplies, and/or luggage, etc. Also, it
was not designed as a structural mem-
ber of the vehicle, and thus cannot prop-
erly carry any additional loads other than
environmental (rain, snow, etc.).
56
CAUTION!
• Do not move your vehicle until the top
has been either fully attached to the
windshield frame and bodyside, or fully
removed.
• The removal of the hard top requires four
adults located on each corner. Failure to
follow this caution could damage the
hard top.
Dual Top — If Equipped
If your vehicle is equipped with a Dual Top,
the soft top system will be provided in a
separate box located in the rear of the vehicle
for shipping purposes only.
If the soft top is removed, ensure the lift
assist mechanisms on both sides of the folded
soft top are in the "lock" position before
removal, and that an audible "click" is heard
when pushing down on the #1 bow from each
of the lift assist mechanisms.
Lift Assist Mechanism
1 — Lock Position
2 — #40 Torx Head Screws
NOTE:
• The soft top and the hard top are to be used
independently.
• Your vehicle warranty will not cover damage
resulting from both tops being installed at
the same time.
• For complete owner information, refer to your
Owner's Manual for further details.