Clock Setting; Audio Setting - Jeep Wrangler 2018 User Manual

CAUTION!
Do NOT attach any object to the touchscreen,
doing so can result in damage to the touch-
screen.

Clock Setting

To start the clock setting procedure:
1. Press the "Settings" button on the face-
plate, then press the "Clock and Date"
button.
2. Press the "Set Time" button on the
touchscreen.
3. Press the "Up" or "Down" arrows to ad-
just the hours or minutes, then select the
"AM" or "PM" button on the touchscreen.
You can also select 12hr or 24hr format
by pressing the desired button on the
touchscreen.
4. Once the time is set, press the "Done"
button on the touchscreen to exit the time
screen.
256
NOTE:
In the Clock Setting Menu you can also select
"Display Clock". Display Clock turns the
clock display in the status bar on or off.

Audio Setting

1. Press the "Settings" button on the face-
plate.
2. Scroll down and press the "Audio" button
on the touchscreen to open the Audio
menu.
3. The Audio Menu shows the following op-
tions for you to customize your audio
settings.
Equalizer
Press the "Equalizer" button on the touch-
screen to adjust the Bass, Mid and Treble.
Use the "+" or "-" button on the touchscreen
to adjust the equalizer to your desired set-
tings.
Balance/Fade
Press the "Balance/Fade" button on the
touchscreen to adjust the sound from the
speakers. Use the arrow buttons on the
touchscreen to adjust the sound level from
the front and rear or right and left side speak-
ers. Press the center "C" button on the
touchscreen to reset the balance and fade to
the factory setting.
Speed Adjusted Volume — If Equipped
Press the "Speed Adjusted Volume" button
on the touchscreen to select between OFF, 1,
2 or 3. This will decrease the radio volume
relative to a decrease in vehicle speed.
Loudness — If Equipped
Press the "Loudness" button on the touch-
screen to select the Loudness feature. When
this feature is activated it improves sound
quality at lower volumes.
Surround Sound — If Equipped
Press the "Surround Sound" button on the
touchscreen, select "On" or "Off" followed
by pressing the back arrow button on the
touchscreen. When this feature is activated,
it provides simulated surround sound mode.