Bulb Replacement - Jeep Wrangler 2018 User Manual

Bulb Number
Rear Base Tail Lamp LED – (Serviced At
Side Marker Authorized Dealer)
Center High-Mounted LED – (Serviced At
Stop Lamp Authorized Dealer)
License Lamp
Rear Fog W21W
NOTE:
Numbers refer to commercial bulb types that
can be purchased from an authorized dealer.
If a bulb needs to be replaced, visit an
authorized dealer or refer to the applicable
Service Manual.

Bulb Replacement

NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as
atmospheric conditions change to allow the
condensation to change back into a vapor.
Turning the lamps on will usually accelerate
the clearing process.
Halogen Headlamps
NOTE:
We advise referring to an authorized dealer
for service.
1. Open hood and support using prop rod.
W5W
2. Remove the front grille. Turn the retainers
along the top 1/4 turn counterclockwise
and remove.
3. Pull the bottom of the grille away starting
at one side and working toward the other.
4. Remove the three screws holding the
headlamp to the vehicle.
5. Remove lamp from the vehicle.
6. Remove the lamp from the collar.
7. Grasp the bulb and turn 1/4 turn counter-
clockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock
position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and
push the connector locking tab to the
lock position.
CAUTION!
Do not touch the new bulb with your fin-
gers. Oil contamination will severely
shorten bulb life. If the bulb comes in
contact with any oily surface, clean the
bulb with rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb
1/4 turn clockwise.
173