Jeep Wrangler 2018 User Manual page 88

WARNING!
disabled, and the enhanced vehicle sta-
bility offered by the ESC system is re-
duced.
• Trailer Sway control (TSC) is disabled
when the ESC system is in the "Partial
Off" mode.
Full Off — If Equipped
This mode is intended for off-highway or
off-road use only and should not be used on
any public roadways. In this mode, TCS and
ESC features are turned OFF. To enter the
"Full Off" mode, push and hold the "ESC
Off" switch for five seconds while the vehicle
is stopped with the engine running. After five
seconds, a chime will sound, the "ESC Off
Indicator Light" will illuminate, and the
"ESC OFF" message will display in the in-
strument cluster. To turn ESC ON again,
momentarily push the "ESC Off" switch.
NOTE:
System may switch from ESC "Full Off" to
"Partial Off" mode when vehicle exceeds a
predetermined speed. When the vehicle
86
speed slows below the predetermined speed
the system will return to ESC "Full Off".
ESC modes may also be affected by drive
modes if so equipped.
WARNING!
• In the ESC "Full Off" mode, the engine
torque reduction and stability features
are disabled. Therefore, enhanced ve-
hicle stability offered by the ESC system
is unavailable. In an emergency evasive
maneuver, the ESC system will not en-
gage to assist in maintaining stability.
ESC "Full Off" mode is intended for
off-highway or off-road use only.
• The Electronic Stability Control (ESC)
cannot prevent the natural laws of phys-
ics from acting on the vehicle, nor can it
increase the traction afforded by prevail-
ing road conditions. ESC cannot prevent
all accidents, including those resulting
from excessive speed in turns, driving on
very slippery surfaces, or hydroplaning.
ESC also cannot prevent collisions.
ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the
ignition is turned to the ON mode.
It should go out with the engine
running. If the "ESC Activation/Malfunction
Indicator Light" comes on continuously with
the engine running, a malfunction has been
detected in the ESC system. If this light
remains on after several ignition cycles, and
the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph
(48 km/h), see an authorized dealer as soon
as possible to have the problem diagnosed
and corrected.
The "ESC Activation/Malfunction Indicator
Light" (located in the instrument cluster)
starts to flash as soon as the tires lose trac-
tion and the ESC system becomes active.
The "ESC Activation/Malfunction Indicator
Light" also flashes when TCS is active. If the
"ESC Activation/Malfunction Indicator Light"
begins to flash during acceleration, ease up on