Boston Scientific LATITUDE Series Patient Manual page 27

3. Plug one end of the Communicator telephone
cord (included) into the jack labeled
4. You may need to use a telephone jack adapter
(provided). If you do, plug the other end of the
telephone cord into the telephone jack adapter.
Then plug the other end of the cord into the
telephone jack on the wall.
Note: If you have DSL internet service, you may
need to use a DSL filter between the telephone
wall jack and the Communicator. Refer to "DSL
Internet Service" on page 65.
5. Optional: To use a telephone with this wall jack,
you may plug your telephone into the jack labeled
or into the telephone jack adapter.
Note: Your Communicator and a telephone can
share the same telephone wall jack. However,
they cannot be used at the same time.
6. When the Heart button flashes, press it.
• Your Communicator's wave lights will flash
green in sequence and repeat for several
minutes as shown in "Using the Heart Button"
on page 33.
• If you have previously completed initial setup,
the Heart button will not flash at this point.
7. Your Communicator has successfully connected
to the LATITUDE system if the wave lights are lit a
solid green as shown below.
LATITUDE Communicator Patient Manual
™
.
23