Graco Reactor E-10hp Instructions Manual page 15

Motor/Pump Control Function Knob
Use the knob (AV) to select desired function
Icon Setting
Park
Slow
Recirculation
Fast
Recirculation
Pressure
Adjust
Motor/Pump Status Codes
If error occurs, the status indicator (AY) will blink 1 to 19
times to indicate the status code, pause, then repeat, or
will blink other active error codes. See T
brief description of status codes.
Table 1: Motor/Pump Status Codes
Number Name
1 Pressure imbalance between ISO and RES
sides
2 Pressure deviation from setpoint
3 Pressure transducer ISO failure
4 Pressure transducer RES failure
5 Excessive current draw
6 High motor temperature
7 No cycle counter switch input
8 High cycle rate deviation (more than 1.0
GPM)
High cycle rate shutdown (more than 1.1
GPM)
9 Low tank level
10 Not used
11 Locked motor rotor
12 Motor controller bus overvoltage
13 Motor controller bus undervoltage
14 Motor controller high temperature
15-19 Motor controller fault
NOTE: The default is to shut down if a status code
indication occurs.
332144H
.
Function
Stops motor and
automatically parks pumps.
Slow recirculation speed.
Fast recirculation speed.
Adjusts fluid pressure to
gun in spray mode.
1 for a
ABLE
Heater Control Diagnostic Codes
Heater control diagnostic codes appear on the
temperature display. These alarms turn off heat.
Table 2: Heater Control Diagnostic Codes
Code Name
01 High fluid temperature
02 High zone current
03 No zone current with heater on
04 Thermocouple not connected
05 High controller temperature
06 No communications with zone
pod
09 Display is missing
99 No communication with heater
control module
Tank Level Sensor LED
The tank level sensor LED (AX) is triggered when
chemical is not present in either tank.
Table 3: Tank Level Indicator (AX)
Chemical
> 1 gallon
< 1 gallon
Controls and Indicators
Alarm Zone
Individual
Individual
Individual
Individual
Individual
Individual
Individual
Individual
Status
Off
Flashing
15