Connection To Waterworks; Commissioning And Testing; Maintenance Of The Appliance - Bartscher 900 Series Instruction Manual For Installation, Maintenance And Use

−
Connect the terminal on the lower right-hand side marked with the international symbol a connector with a
nominal cross section <10 mm
connected like this.
It's strictly forbidden using the pending electric cable connected with terminal board,
overhanging from the frame, to connect definitely the machine.
ATTENTION!
Cut the tension before to make the connection and/or maintenance .
- Water inlet pressure must be between 50 and 300 kPa, otherwise install a pressure regulator on the line
before the appliance.
Install a cut-off valve for each supply on the line before the appliance.
-
Make connections according to regulations currently in force.
-
Water connections to 12mm. are fitted in the lower part on the left-hand side of the appliance.
-
- Once all the connections have been made, the appliance and the overall installation must be checked
following the directions given in this manual.
−
Check in particular:
−
that the protective film has been removed from the external surfaces;
that the terminal board housing, removed for electrical connections, has been reinstalled.
that connections have been made in accordance with the requirements and directions indicated in this
manual;
−
that all safety requirements in current standards, statutory regulations and directives have been met;
−
that the water connections are leak-free;
−
that the electrical connection has been performed according to standards.
- In addition, check that once the appliance has been installed, the power cord is neither subject to stretch
nor in contact with nor surfaces.
Now proceed to light the appliance as directed in the instructions for use.
-
While the appliance is in use, voltage should not differ from the nominal voltage more than +/- 10%.
-
- The test report must be completed in full and submitted to the customer who should then sign in
acceptance. With effect from this moment, the appliance is covered by the manufacturer's warranty.
Warning! : All maintenance operations shall only be performed by a technically qualified service
centre!
To ensure correct and safe operation, the appliance must be inspected and serviced at least once a year
-
only. Maintenance includes also to control the components and tear of pipes, feeding pipes, electrical
components etc..
It is advisable to replace worn components during maintenance operations to avoid the need for other
-
maintenance calls and unexpected failures.
Instruction manual for installation, maintenance and use
Electric tilging cooker Serie 900
2
. All the appliances installed and the earth system of the building shall be

2.2.2. CONNECTION TO WATERWORKS

2.3. COMMISSIONING AND TESTING

2.4. MAINTENANCE OF THE APPLIANCE

12.15.01 - EN 29