Transporting The Device; Establishing The Power Supply; Inserting Batteries - Seca 787 Instructions For Use And Warranty

4.4 Transporting the device

4.5 Establishing the power supply

Inserting batteries

24 •
The device is equipped with two casters to facilitate transport over short
distances.
1. If necessary, remove the plug-in power supply unit from the power socket
and from the device.
2. Fold down the measuring flap and push the upper telescopic element of
the measuring rod into its lowest position.
3. Take hold of the recessed handle of the device.
4. Tilt the device until it can be moved freely on the casters.
5. Move the device slowly and carefully over door sills.
CAUTION!
Incorrect measurement as a result of incorrect setup location and
incorrect ambient conditions
Soft floors such as wooden hallways, for example, give under the
patient's weight and falsify the measuring result. Incorrect ambient
conditions lead to measurement errors.
► Select a setup location with a level, stable floor in order to achieve
precise measuring results.
► Use the device only in the intended ambient conditions
(➔ "Technical data", page 40).
6. Transport the device to its new setup location.
7. Set the device in an upright position.
8. If necessary, plug the plug-in power supply unit into the device and into
the power socket (➔ "Connecting the plug-in power supply unit (variant-
dependent)", page 25).
You need six AA-type batteries, 1.5 V.
NOTE
If you want to use the WiFi function or a barcode scanner (variant-
dependent), the power consumption of the device rises significantly. In
these cases, operate the device with the plug-in power supply unit
provided.
To establish the power supply, proceed as follows:
1. Open the battery compartment:
a) Hold the battery compartment lid steady
b) Remove the cross-head screw behind the battery compartment lid
c) Remove the battery compartment lid