Water Tank For Cdf 10; Installation Of The Water Tank; Access To The Control - Dantherm CDF 10 Service Manual

2.3 Water tank for CDF 10

If it is not possible to mount a fixed or a flexible drain outlet connection, the CDF 10 can be used with a water tank.
The water tank is mounted beneath the CDF 10 as shown on the drawing below.
If the CDF 10 is used with a water tank, it switches off automatically when the water tank is full. A red LED on the
front panel lights when the water tank needs to be emptied.
The water tank is an extra accessory for the CDF 10 and is available on demand.
The water tank consists of the following parts:
•
Water tank cabinet with magnetic switch for water stop and cable for connection to PCB
•
Water tank
•
4 machine screws
2.3.1 Installation of the water tank in the CDF 10
1. Place the CDF 10 on the wall by means of the wall
suspension bar.
2. Then dismantle the front panel of the CDF 10.
3. Fix the water container cabinet by 4 machine screws
under the bottom of the CDF 10.
4. Take the supply cable through the diaphragm bush at the
bottom of the water tank cabinet.
5. The control of the CDF 10 is placed in a box behind the
front panel. To get access to the control, unscrew the 4
screws on the sides of the box and remove the box lid.
6. Take the cable from the magnetic switch through the
diaphragm bush at the bottom of the CDF 10 and connect
it to the terminal strip on the PCB – terminal points 13/14
(WATER SW).
7. Remount the control box lid and the front panel.
8. Place the water tank in the water tank cabinet. The float
must be turned towards the magnetic switch.

2.4 Access to the control

Remove the front panel by unscrewing the two screws on the top of the dehumidifier. Lift the front panel vertically
upwards and then pull it horizontally away from the unit.
The control of the unit is located in a box behind the front panel. To get access to the control unscrew the 4 screws
on the sides.
11