User Manual
GFK-3066 Rev. A
6. Once power is applied, the unit begins initializing. The first thing to display is the splash screen.
Be sure to connect a DC power cord to this 3-pin power connector. Using a voltage out of the range may fail
to boot the system or cause damage to the system board.
2.3.3
Graphics Interface
The display port consists of the following:
•
1 DP++ port
2.3.3.1
DP++ Port
The DP++ is a digital display interface used to connect a display device such as a computer monitor. It is
used to transmit audio and video simultaneously. The interface, which is developed by VESA, delivers higher
performance features than any other digital interface.
2.3.3.2
BIOS Setting
Configure the display device in the Chipset menu ("DISPLAY control" submenu) of the BIOS. Refer to the
chapter 3 for more information.
2.3.4
RJ45 LAN Ports
2.3.4.1
Features
2 Intel® I210IT PCI Express Gigabit Ethernet controllers (4 on larger box module)
The LAN ports allow the system board to connect to a local area network by means of a network hub or
router.
2.3.4.2
BIOS Setting
Configure the onboard LAN in the Advanced menu ("Wakeup Configuration" submenu) of the BIOS. Refer to
chapter 3 for more information.
BIOS Setup
•
Solid green during normal operation
Section 1
May 2019
26