User Manual
GFK-3066 Rev. A
3.2.17.1
WatchDog Count Mode
A WatchDog timer (WDT) is a hardware timer that automatically generates a system reset if the main
program neglects to periodically service it. It is often used to automatically reset an embedded device that
hangs because of a software or hardware fault. Use this menu to select the WatchDog Timer Unit: second or
minute.
3.2.17.2
WatchDog Timeout Value
Enter the value to set the Super IO WatchDog timer. 0 means disabled.
3.2.18
Network Stack Configuration
This section is used to enable or disable network stack settings. The Network Stack Controls LAN1 & LAN2
(Also LAN 3 & LAN4 on large computing module).
BIOS Setup
Section 1
May 2019
42