Connecting Input Power (24V DC-in)
To connect to power, follow these steps:
1. Verify that the power cable is not energized.
2. Loosen the screw clamps on the mating power connector.
3. Strip the insulation from the power cables.
4. Secure the power cable to the mating connector, noting polarity,
and tighten the screw clamps. The torque for the attaching
screws is 0.3 Nm (2.26 in-lb).
5. Apply dc power to the unit. During normal startup and operation, the LED status indicator displays
as follows:
6. Once power is applied, the unit begins initializing. The first thing to display is the splash screen.
Be sure to connect a DC power cord to this 3-pin power connector. Using a voltage out of the range may
fail to boot the system or cause damage to the system board.
Graphics Interface
The display port consists of the following:
DP++ Port
The DP++ is a digital display interface used to connect a display device such as a computer monitor. It is
used to transmit audio and video simultaneously. The interface, which is developed by VESA, delivers
higher performance features than any other digital interface.
BIOS Setting
Configure the display device in the Chipset menu ("DISPLAY control" submenu) of the BIOS. Refer to the
chapter 3 for more information.
RJ45 LAN Ports
Features
2 Intel® I210IT PCI Express Gigabit Ethernet controllers
The LAN ports allow the system board to connect to a local area network by means of a network hub or
router.
BIOS Setting
Configure the onboard LAN in the Advanced menu ("Wakeup Configuration" submenu) of the BIOS.
Refer to chapter 3 for more information.
15
•
Solid amber while the RXi - Industrial Display unit is starting up
•
Solid green during normal operation
RXi – Panel PC Quick Start Guide
GFK-3072B