AEG BSK774121M User Manual page 18

18 www.aeg.com
5. Press
6. Set the temperature.
7. Press
7.7 Setting a steam function
The water drawer cover is in the control
panel.
WARNING!
Use only cold tap water. Do
not use filtered
(demineralised) or distilled
water. Do not use other
liquids. Do not put
flammable or alcoholic
liquids into the water
drawer.
1. Press the cover of the water drawer
to open it.
2. Fill the water drawer with 900 ml of
water.
The water supply is sufficient for
approximately 55 - 60 minutes.
3. Push the water drawer to its initial
position.
4. Turn on the oven.
5. Set a steam heating function and the
temperature.
6. If necessary, set the function:
Duration
When the steam generator is
empty, the signal sounds.
The signal sounds at the end of the
cooking time.
7. Turn off the oven.
8. Empty the water tank after the steam
cooking is completed. Refer to the
cleaning function:Tank Emptying.
CAUTION!
The oven is hot. There is
a risk of burns. Be careful
when you empty the
water tank.
9. After steam cooking steam can
condensate on the bottom of the
cavity. Always dry the bottom of the
cavity when the oven is cool.
Let the oven dry fully with the door open.
to confirm.
to confirm.
or: End Time
WARNING!
Wait a minimum of 60
minutes after each use of the
steam cooking in order to
prevent hot water from
exiting the water outlet
valve.
7.8 Tank Empty indicator
The display shows: Water required and a
signal sounds when the tank is empty
and must be refilled.
For more information refer to "Daily use"
chapter, Setting a steam function.
7.9 Tank Full indicator
When the display shows: Water tank full,
you can use the steam cooking.
A signal sounds when the tank is full.
If you put too much water
into the tank, the safety
outlet moves the excess
water to the bottom of the
oven.
Remove the water with a
sponge or cloth.
7.10 Emptying the water tank
.
CAUTION!
Make sure that the oven is
cold before you start to
empty the water tank.
Empty the water tank after each steam
cooking.
1. Prepare the draining pipe (C),
included in the same package with
the user manual. Put the connector
(B) onto one of the ends of the
draining pipe.