Lexmark C520 Series Service Manual page 70

5022-xxx
Error Sub
Primary message
code code
37 xx Insufficient memory,
some held jobs were lost
38 xx Memory Full
50 xx PPDS font error
51 xx Defective flash detected
52 xx Not enough free space
in flash memory for
resources
53 xx Unformatted flash
detected
54 xx Serial option <x> error
54 xx Network <x> software
error
2-12
Service Manual
Action
• The printer was unable to restore some or all of the confidential or held
jobs on the hard disk.
• Press until Continue appears, and then press
message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
message and continue printing.
The job may not print correctly.
• Cancel the current job.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
message and continue printing.
Downloaded fonts and macros not previously stored in flash memory are
deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
message and continue printing.
• Format the flash memory before storing any resources on it. If the error
message remains, replace the flash memory.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Make sure the serial link is set up correctly, and the appropriate cable is
in use.
• Make sure the serial interface parameters (protocol, baud, parity, and
data bits) are set correctly on the printer and host computer.
• Press until Continue appears, and then press
message and continue printing.
The job may not print correctly.
• POR the printer. If this does not fix the problem, replace system card. Go
to "System card removal" on page
• Press until Continue appears, and then press
message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• POR the printer. If this does not fix the problem, replace system card. Go
to "System card removal" on page
4-47.
4-47.
4-47.
4-47.
4-47.
4-47.
4-47.
4-47.
to clear the
"System
to clear the
"System
to clear the
"System
to clear the
"System
to clear the
"System
to clear the
"System
to clear the
to clear the